Door Won't Latch or Stay Closed
A door that swings open on its own or needs a shove to click shut often has an alignment problem between the latch and the strike plate.
Common causes
Hinge screws pulled loose
The top hinge carries most of the door's weight. When its screws loosen, the door sags and the latch drops below the strike opening.
Strike plate out of position
The house settles and frames shift slightly over time; a strike that was aligned years ago can end up a few millimeters off.
Seasonal swelling
Humidity can swell a door or frame enough that the latch no longer reaches, then the problem eases in drier months.
Worn latch mechanism
A latch that sticks inside the door or doesn't spring out fully can't catch the strike even when alignment is right.
What you can safely check
- Close the door slowly and watch where the latch meets the strike — high, low or short.
- Tighten all hinge screws with a hand screwdriver; don't overtighten into stripped holes.
- Look for shiny rub marks on the frame that show where the door contacts it.
- Turn the knob and confirm the latch retracts and springs back smoothly.
Stop and call a professional if
- Hinge screws spin without tightening — the holes need to be repaired, not forced.
- It is an exterior or entry door and it no longer locks reliably.
- The frame is cracked, split or soft from moisture.
What a visit covers
- Diagnose alignment at the hinges, latch and strike
- Repair stripped hinge holes and reset hinges
- Adjust or relocate the strike plate, or replace a worn latch
- Test the door and any lock through several cycles
This is handled as part of door repair in Atlantic & Cape May Counties. Work that requires a licensed electrician, plumber or other specialty trade is identified up front and referred out.
Questions
Want it looked at?
Send a short description and a photo. We will confirm whether it's in scope and what it should take before scheduling.
