Skip to main content
Locksmith · Troubleshooting

Deadbolt Won't Lock or Is Hard to Turn

If you have to push or lift the door to throw the deadbolt, the lock is usually fine — the bolt is hitting the edge of the strike.

Common causes

  • Bolt hitting the strike

    Door sag or a shifted frame means the bolt meets wood or metal instead of the strike hole.

  • Shallow strike pocket

    If the hole behind the strike isn't deep enough, the bolt can't extend fully.

  • Worn or dirty cylinder

    A key that turns stiffly even with the door open points to the cylinder itself.

What you can safely check

  • Open the door and turn the deadbolt — if it moves freely, the problem is alignment.
  • Look at the strike for scrape marks showing where the bolt is hitting.
  • Use a graphite or lock-specific dry lubricant, not oil-based sprays, if the cylinder is stiff.

Stop and call a professional if

  • The bolt won't extend at all, leaving an entry door unsecured.
  • The key is bent, broken or stuck in the cylinder.

What a visit covers

  • Diagnose alignment versus cylinder wear
  • Adjust the door and strike or deepen the bolt pocket
  • Service, rekey or replace the deadbolt where needed

This is handled as part of deadbolt installation in Atlantic & Cape May Counties. Work that requires a licensed electrician, plumber or other specialty trade is identified up front and referred out.

Want it looked at?

Send a short description and a photo. We will confirm whether it's in scope and what it should take before scheduling.